Istanbul Intl

105504 – Julian 01/30/2025

Large draped polygon exclusion removed. Small forest exclusion added.

105408 – HBuberci 01/25/2025

Added dual jetway support and did minor changes.

103372 – tepman123 08/16/2024

Added 'VEFA' and 'PERA' on taxiway D and C. Added draped polygon on intersection D and N6.

100596 – HBuberci 02/02/2024

Added exclusion zone to remove forests.

100556 – HBuberci 01/31/2024

Added new taxiway D extension towards North to join C at a 45 degree angle. Extended SE apron to match the Esri aerial images.

96917 – HBuberci 07/08/2023

Non-structural minor corrections/alterations.

96864 – HBuberci 07/05/2023

Finally! Will test further to see if I mised to correct any part of this majestic project and I sure hope that they stop expanding the airport.

96026 – HBuberci 05/18/2023

Uploading to see if there is/are any cause for rejection up to this point while continuing to work further.

94894 – HBuberci 03/30/2023

This upload is just to make sure if custom "roads" are meeting the gateway requirements. I will continue with correcting apron/ramp markings based on current esri imagery.

94410 – HBuberci 03/11/2023

Still a WIP (100% overhaul) but would be nice to see if I missed anything along the way. Western runways with exits, state apron, cargo aprons and maintenance apron all repositioned and re-drawn as per underlying ESRI imagery. Taxiways A and B fully completed, currently working on Northern maintenance and de-icing apron. Will upload further copies until I receive a comment from your side.

94140 – HBuberci 02/17/2023

Corrected jetway positions, removed some unnecessary polygons, had to add 3 exclusion zones to remove roads and added tunnels. Will proceed with adding other tunnels if these are acceptable iand f not I will remove them. Due to severe terrain problems, had to apply flatten option.

89904 – HBuberci 03/02/2022

Removed all forests and tree obj files, removed exclusion zones outside of the airport boundary along with a few windmills.

83796 – RamtinAlirza 04/04/2021

Made the terminal look accurate

80362 – HBuberci 10/06/2020

Corrected short taxiway join to RWY 16L/34R, checked all others for similar problem.

80050 – HBuberci 09/18/2020

Removed the problematic taxi routes as requested.

79711 – HBuberci 09/01/2020

New runway 18/36 added with all surrounding taxiways, taxi signs and ATC routes. Terminal pier facades changed, numerous minor changes made to make the scenery look closer to real life.

75851 – HBuberci 03/23/2020

Replaced all 6 mid_modern_04.fac to high_modern_06.fac as per recommendation.

75245 – HBuberci 02/28/2020

New version based on real images for ground markings, placement of Terminal and other building's within the complex. Taxi Routes are based on official charts and a few taxi routes are extended towards the ramp starts to avoid AI aircraft attempting to join the closeby routes. Can delete them if required.

69361 – HBuberci 06/30/2019

Covered the airport area with one of the proposed draped polygons.

69103 – HBuberci 06/20/2019

Threshold markings removed, minor corrections made.

68405 – HBuberci 05/20/2019

Removed some objects and re-positioned some others.

68061 – HBuberci 05/08/2019

Removed ATC Route extensions to ramps.

67657 – HBuberci 04/21/2019

Enhanced the scenery with more facades, objects, polygons, lines etc. Corrected all apron/taxiway lines as per the FAA documents (as much as I could). Added ALL available ATC frequencies. Still a WIP and next step will be to add some more objects to aprons and cargo area. edit: Re-uploaded with "Always flatten" option checked.

67656 – HBuberci 04/21/2019

Enhanced the scenery with more facades, objects, polygons, lines etc. Corrected all apron/taxiway lines as per the FAA documents (as much as I could). Added ALL available ATC frequencies. Still a WIP and next step will be to add some more objects to aprons and cargo area.

64679 – HBuberci 12/10/2018

Added Piers and Jetways to the terminal. I am aware that some ground markings and gate numbers look crooked probably due to a certain bug in WED (might be because of importing the data to a new file to get them organized) but I will try to correct them later on when I have time.

64395 – HBuberci 11/26/2018

Enhanced the scenery with more details but still a WIP. Split up the ground level facades to allow Ground traffic to use them as shortcuts as in reality.

64085 – HBuberci 11/08/2018

V1 and V2 ramp starts shifted towards South for Heli trafiic but left the taxi Routes intact.

63899 – HBuberci 10/30/2018

Enhanced the layout and details further yet still a WIP.

63609 – HBuberci 10/15/2018

More and more polygons, lines, signs and ATC routes added. My aim is to get basics approved so that there will be less work by the time of opening.

63563 – HBuberci 10/13/2018

Initial upload. ATC routes for 4 runways completed, Center Aprons completed. Taxi signs and markings for runways 16L/34R and 16R/34L are completed. All Ramp starts are placed based on actual coordinates and aircraft types. Terminal area is still to be added.