HAYRİ BÜBERCİ reported issue XSG-6168: New Airport Code Request on October 10, 2018 11:18 AM
Closed
PaulCankaya commented on December 5, 2018 10:28 AM

LTFM 'Not in database' when trying to input as destination airport.

HAYRİ BÜBERCİ commented on December 5, 2018 1:37 PM

NOT IN DATABASE error is specific to ZIBO mod and not to default B737-800 or any of the payware aircraft that I had tested like A320, B777, B767 of FF and B748i of SSG.. We had informed him about the issue but did not get a positive response yet and you have to add your request in his thread. This scenery has got nothing to do with that error AFAIK.

PaulCankaya commented on December 5, 2018 4:31 PM

I understand. However, I even tried to input LTFM into the default aircraft Garmin GPS. This did not recognise LTFM in the system either? The scenery is great.

HAYRİ BÜBERCİ commented on December 5, 2018 4:43 PM

I am using Zibo v 3.31e which sees LTFM but not the coordinates though.

hckaynak commented in reference to scenery pack 64679 on January 22, 2019 5:15 AM

I am using xplane 11.30 Why there isn't ILS enveloppe for this very nice LTFM airport ? It is a general issue or only my problem ? Many thanks for the scenery

HAYRİ BÜBERCİ commented in reference to scenery pack 64679 on January 22, 2019 5:41 AM

Currently it is a general issue and I have a temporary solution to this problem. I will share the link if I get the permission to do so.

ssa943 commented in reference to scenery pack 64679 on February 4, 2019 10:01 AM

Would be very happy to have a solution albeit temporary.

HAYRİ BÜBERCİ commented on February 4, 2019 10:11 AM

https://forums.x-plane.org/index.php?/forums/topic/169085-ltfm-istanbul-airport-ils-and-database-problem/&tab=comments#comment-1577082 The solution to this temporary problem is detailed in the thread, pls read carefully and apply.

ssa943 commented on February 4, 2019 3:41 PM

Thanks a lot!

woozy reported issue XSG-7092: LTFM LOC AND GS for all run... on February 21, 2019 11:11 AM
Closed

The new ISL airport needs to be included with ILS NAVAIDS.

  • Robin Peel May 26, 2019 12:19 AM

    Thanks! The new ILSs have been added to LTFM and will be included in the next release of X-Plane that includes updated ILS data. - Robin

ilhanarca reported issue XSG-7336: ISTANBUL AIRPORT(LTFM) not... on April 4, 2019 12:22 PM
Closed

In latest version "11.32" version when i open fmc, i cannot select LTFM as a departure or arrival in default 737-800, fmc says "NOT IN DATABASE". I'm using latest navigraph data.

  • Julian Lockwood April 11, 2019 1:14 AM

    LTFM is a new identifier. It will be supported in future nav data releases.

Fwattyov reported issue XSG-7399: Missing ATIS FREQ in reference to scenery pack 64679 on April 13, 2019 4:37 PM
Closed

Missing ATIS in apt.dat file...
126.35 and/or 128.85

  • Jan Vogel March 2, 2021 11:19 AM

    Both frequencies now valid in Xplane, this report can be closed.

Fwattyov commented in reference to scenery pack 64679 on April 13, 2019 4:34 PM

Hi,

Looks fantastic...doing a flight from LTFM/HECA... Noticed no ATIS...apt.dat is missing FREQ: 126.35 and/or 128.85

Thanks for your work.

Ferhat0755 reported issue XSG-7583: LTFM Airport NOT IN DATAB... on May 5, 2019 10:24 AM
Closed

dear people of the xplane i have a short question xplane 11 after the update there is now also the airport of istanbul LTFM available so i dont have to go download a scenery suit because i see it immediately in my xplane 11 that it is available and a very nice airport am very satisfied itself only xplane has released itself but why can't I enter standard planes zibo and ultimate planes in the fms so the problem is that there is not in the database what can I do is it later on z ' n work after updates because I have navigraph myself so my xplane 11 and GNS is up to date please help I want to fly

  • Philipp Ringler May 13, 2019 7:17 PM

    That's the perfect example of what we're talking about. LTFM needs to be taken down to the default airports.

  • Jan Vogel March 10, 2023 12:01 PM

    LTFM is now established in the XP database with XP12.

ericmcray reported issue XSG-7605: Different WorldEditor Version in reference to scenery pack 64679 on May 7, 2019 9:28 PM
Closed

I tried HBuberci fix that he is posted but It didn't work for me too.

LTFM apt.dat WorldEditor version is 2.0.0r4
Xplane default scenery apt.dat WorldEditor is 1.7.1r2

MarilynBlack reported issue XSG-8339: LTFM ILS Problem in reference to scenery pack 69361 on August 5, 2019 6:53 PM
Closed

Hello, There are ils problems in LTFM. Can you fix this please?

  • HAYRİ BÜBERCİ August 6, 2019 7:06 AM


    Please update to X-plane 11.35 and uncheck "Disable downwind ILS" option from settings to see all 4 ILS feathers in the default MAP view. Here are 2 screenshots showing ILS feathers at LTFM and LTFM STARS while located at another nearby default airport.

FatihKoz reported issue XSG-10995: Airport Vehicles on taxiway... in reference to scenery pack 80362 on October 19, 2020 11:09 AM
Closed

Airport vehicles freely roaming around approach lights of Rwy18. Also some moving vehicles appear on taxiways around Rwy18 and they do cross the runway.

  • HAYRİ BÜBERCİ October 19, 2020 7:20 PM


    I tested the scenery 2 days ago after reading your post in the forums by doing a 10 nm approach towards RWY 36 and could not see a single ground traffic vehicle wandering over the grass, roaming around approach lights or crossing the runway/taxiway. There is a gT parking beside the VIP terminal and all traffic routes head towards Westerly direction. I have no ground traffic route set around RWY 18, only on Apron 1 which is 1.5 km away from RWY 18. Pls make sure that you have only one LTFM scenery in your Custom scenery folder. The old version had a traffic route along taxiway G in North/South direction and entered Apron 1 before ARFF building. Whole route was removed in the latest version.

  • FatihKoz October 21, 2020 10:05 PM


    Hi, I have no other sceneries for LTFM installed (tested some non Gateway sceneries but not using them). I had no problems while approaching Rwy36 , ground traffic only appears while approaching Rwy18 from north (published 1B STARs was used from both west and east). Thanks again for your efforts, this may be a problem from my end, since the traffic is harmless I can accept their existence

  • HAYRİ BÜBERCİ November 9, 2020 5:19 PM


    I will do some more tests tomorrow by approaching from North. I must remind you that there is a service vehicle parking area right after the taxiway H, towards the West of the VIP Terminal. The (ground) traffic you are seeing might be those that are using the parking lot. I will check whether they are moving out of their routes or not.

  • Jan Vogel March 12, 2021 7:11 AM

    HBuberci uploaded a new version that may fix this - we will check again when it is injected into XPlane with one of the next updates. I will leave this report as “in progress” until then.

  • Jan Vogel August 30, 2021 5:54 AM

    This should be fixed now.

nestor1010 reported issue XSG-11067: gateway in reference to scenery pack 80362 on November 9, 2020 11:01 AM
Closed

gatewayler otomatik kendisi kapanıp açılmıyor
HSBC yazıları yok
Bu hataların düzeltilmesi lazım
Şimdiden teşekkürler

  • HAYRİ BÜBERCİ November 9, 2020 5:27 PM


    What you categorize as "errors" are not actually errors. You should know that "custom objects" like HSBC panels or moving jetways are not allowed in Gateway sceneries. You can search for one of the other "custom" versions of the scenery from the internet.
    Bahsettikleriniz "hata" değil, Gateway senaryoları içinde HSBC panelleri ya da hareketli körükler gibi "özel yapım modellemeler" kullanılamaz, ondan dolayı "bilerek" kullanılmamışlardır. Eğer özel çalışma istiyorsanız o versiyonları internetten arayıp indirebilirsiniz.

erennx reported issue XSG-11188: empty Scenery on December 13, 2020 4:01 PM
Closed

empty Scenery

halo_thepilot commented on September 9, 2022 1:09 PM

In X-Plane 12 is a big hill in the middle of the airport

HAYRİ BÜBERCİ commented in reference to scenery pack 89904 on September 10, 2022 6:54 PM

I don''t own XP 12 yet so I can''t comment about the "hill" in the middle of the airport, the boundary was properly drawn in the last update.

Matei reported issue XSG-13829: Needs flattened terrain in reference to scenery pack 80362 on January 18, 2023 10:34 PM
Closed

In x Plane 12 the whole airport is covered by trees, and follows ground contours that are extremely uneven.

  • HAYRİ BÜBERCİ January 19, 2023 6:14 AM


    This is a known issue and will be addressed by Laminar (as per triplemon). In the meantime I shared a solution in the forums if you don't want to wait.

couger reported issue XSG-14236: 35l in reference to scenery pack 89904 on May 19, 2023 2:31 PM
Closed

35l pisti neden yok

  • Jan Vogel May 19, 2023 4:00 PM

    I definitely need some yok, too 😜

BoskovicTV reported issue XSG-14860: LTFM Missing earth nav in reference to scenery pack 96917 on November 12, 2023 10:53 PM
Closed

I/DSF: Warning for missing scenery file: +42+029
I/DSF: Warning for missing scenery file: +42+030

eljif99 reported issue XSG-15009: trees in reference to scenery pack 96917 on January 4, 2024 12:57 AM
Open

when i use this there are trees on the airport

flightwusel reported issue XSG-15086: D North of N6 in reference to scenery pack 96917 on January 27, 2024 10:57 AM
Closed

Thanks for the great work on this airport! I think they extended it again D reaches now a bit further North of N6 until it converges into C. It is part of the default departure flow 2G for RWY17L and I just was a bit confused there when VATSIM ATC send me that way

  • HAYRİ BÜBERCİ January 28, 2024 11:32 AM


    I have no knowledge of that convergence but I will check. The chart I have shows instructions as shared here. You need to take left at C7B (just realized that it is shown as N6 in WED taxi routes - my bad!) then right on to C. I don't think taxiway D can extend straight towards North as there is a service road and a deep tunnel ahead of it - at least I have not heard anything about it yet.

  • flightwusel January 29, 2024 9:01 AM


    It seems to be really new. I have it in the chart effective 28th December.

  • HAYRİ BÜBERCİ January 31, 2024 1:50 PM


    I have added the extension and uploaded for approval, thanks for informing.

  • flightwusel January 31, 2024 4:20 PM


    Awesome, thank you!

You must be logged in to participate in the discussion