WED-1254

Runway 0 length made by error crashes XPlane

Closed

New Feature

Reported by:
 Mathieu on December 22, 2019 3:12 PM

Assigned to:
 Jennifer Roberts

Working on an airport upgrade, I made by error a runway with length = 0 and this error was not detected at the validation step. The result was it crash XPlane , either with the proposal to send / cancel the dump file, either a message XPlane is completely out of memory. This control should be implemented on validation step.

  • Michael Minnhaar December 23, 2019 1:22 AM

    Runway minimum length and width are validated - please attached the earth.wed.xml here where this can be exported.

  • Mathieu December 23, 2019 11:06 AM


    Attached the set of files generated by WED (I'm not comfortable with .xml files). In WED the wrong runway is 01/19 under /Taxi lines group

  • Michael Minnhaar December 23, 2019 11:11 PM

    Confirmed - this thing isn’t recognized as a runway at all by validation - so the applicable test is never run on it.