Due to a mesh issue near the end of the rwy24/T5 area, the ground falls away from the taxiway even with the flatten command on. The mesh in the airport area is in need of attention overall.
Checked airport - one of the very few cases where both options (flatten on/flatten off) don´t work!
I tweaked the boundary to hopefully improve this with the next mesh recut (XP12). For now always flatten needs to be on but the taxiway in the very northeast corner is still unusable (terrain sinks, but airport textures like taxiway still stays flat, so aircraft falls “below” taxiway).
Not sure about which Scenery pack (vanilla XP12), but this airport's gates are all fixed to the ground by columns, where IRL there should be wheels and the jetway should be free to move.
You must be logged in to participate in the discussion
Due to a mesh issue near the end of the rwy24/T5 area, the ground falls away from the taxiway even with the flatten command on. The mesh in the airport area is in need of attention overall.
Jan Vogel March 7, 2021 6:18 AM
Checked airport - one of the very few cases where both options (flatten on/flatten off) don´t work!
I tweaked the boundary to hopefully improve this with the next mesh recut (XP12). For now always flatten needs to be on but the taxiway in the very northeast corner is still unusable (terrain sinks, but airport textures like taxiway still stays flat, so aircraft falls “below” taxiway).
Not sure about which Scenery pack (vanilla XP12), but this airport's gates are all fixed to the ground by columns, where IRL there should be wheels and the jetway should be free to move.